[. . . ] A 2D Contour Tracking comb B 3-dimensional rounded chromium steel blades C Hair length selector D On/off switch E Socket for appliance plug F Cleaning brush G Barber's comb H Charge indication light I Mains plug with transformer J Appliance plug K Nose/ear/eyebrow grooming attachment L Storage stand M Trimming attachment 2 Assemble the grooming attachment by inserting its hook into the housing and pushing it down until you hear a click (fig. Do not connect the appliance to the mains again after the battery has been removed. 1 Insert the grooming attachment into one nostril and move it up and down while slowly turning it to remove unwanted hair (fig. [. . . ] 2 Put the grooming attachment against the skin at the root of the nose and move it along the edge of the eyebrow in the direction of hair growth (fig. After a few moments the green pilot light will go on to indicate that the appliance is charging (fig. To optimise the lifetime of the appliance, do not charge it for more than 24 hours. Do not use abrasives, scourers or liquids such as alcohol, petrol or acetone to clean the appliance. 1 Make sure the appliance is switched off and disconnected from the mains before you start cleaning it. 4 Clean the cutting unit and the inside of the appliance with the brush supplied. 5 Reassemble the cutting unit by inserting the hook into the appliance and pushing the unit back onto the appliance until you hear a click (fig. Assemble one of the adjustable combs by inserting the hook of the comb into the appliance and pushing it down until you hear a click (fig. The trimmer has 2 adjustable comb attachments with 5 settings each, allowing you to cut hair to 10 different lengths: Small comb (settings 1-5): resulting in a hair length of 1. The resulting hair length corresponds to the smallest distance between the cutting blade and the spot where the comb is in contact with the skin (fig. 2 To trim in the most effective way, move the trimmer against the direction of hair growth. Make sure the surface of the comb always stays in contact with the skin (fig. A worn or damaged cutting unit should only be replaced with an original Philishave cutting unit, available from authorised Philips service centres. Do not throw the battery away with the normal household waste but hand it in at an official collection point. [. . . ] Cutting without the comb attachment (or with the comb at setting '0') will result in a very short stubble beard. Do not use a damaged or broken cutting or grooming attachment as this may cause injuries. To trim nose hair, ear hair and eyebrows: 1 Move the comb to setting '0' and remove the trimming attachment (fig. [. . . ]